Intellinet-network-solutions PRO SERIES INT-PSNC-UM-1106-06 Uživatelský manuál stáhnout pdf (Strana 105)

- 105 -

Appendix H: Reinstating the Factory Default Settings

This information details how to set the default settings for the Pro Series Network Camera. In

certain circumstances, it may be necessary to restart or reinstate the factory default settings for

your camera. This is done by pressing the Reset button or by using HyperTerminal settings.

Pressing the Reset Button

1. Using a paper clip or any sharp pin, press the Reset button on the back of the camera.

2. Switch off the camera by disconnecting the power cable.

3. While pressing the Reset button, reconnect the power supply cable. Keep the Reset button

pressed until the green Operating Status LED blinks three times (this may take 10 to 15

seconds). Release the Reset button.

Using HyperTerminal

1. Run "HyperTerminal" (see 4.3.1).

2. Supply power to the camera.

3. After a few moments, the countdown begins with the prompt "Press any key to stop auto

booting within 3 seconds..." Press any key to display the screen below.

When you enter "Set," the administrator ID and password reinstate as factory default "admin."

NOTE:

Reinstating the original default settings will cause all parameters (including IP address)

to be reset.

Factory default settings

Administrator ID: admin

Administrator password: admin

Guest ID: guest

Guest password: guest

IP address: 192.168.1.221

Subnet mask address: 255.255.255.0

Gateway address: 192.168.1.1

Server IP address: 192.168.1.5

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 127 128

Žádné komentáře

Intellinet-network-solutions PRO SERIES INT-PSNC-UM-1106-06 Uživatelský manuál Strana 105